BlueStar RNB60 Specifikace

INSTRUCTIONS FOR INSTALLATION, USE AND CARE OF GAS RANGES & COOKTOPS FOR THE HOME MODELS: RPB24, RCS30, RPB30, RNB30, RCS36, RPB36, RNB36,

10 ELECTRICAL CONNECTION There is no connection necessary beyond plugging the unit into a polarized, grounded, 120-volt, 60-Hz, 15-amp circuit.

11 IMPORTANT SAFETY INSTRUCTIONS To avoid personal injury or property damage, please read and follow these important safety precautions. WARNING:

1212. Use only dry potholders. Moist or damp potholders on hot surfaces may result in steam burns. Do not allow potholders to touch hot burner area

13FEATURES FEATURES OF RANGES & COOKTOPS COMPONENT SECTION RANGE SIZE COOKTOP SIZE PAGE 30 36 48 60 30 36 48 Start-Up X

14 THERMAL vs. CONVECTION BAKING THERMAL BAKING EXPLAINED Thermal baking refers to the use of a standard oven, (no convection), where heat is circ

15START-UP, OPERATION & CLEAN-UP All units are wiped clean with various solvents or detergents at the factory to remove visible signs of dirt,

16OPERATION OPEN TOP BURNERS Start-Up Remove the ring grates and top grates and thoroughly wash them with hot, soapy water, rinse, and dry immedia

17OPEN TOP, GRIDDLE, AND CHARBROILER BURNER AIR SHUTTER ADJUSTMENTS Before attempting to adjust any top burner air shutter, assure the following inf

OVEN Start-Up Before turning on your oven for the first time, remove the oven rack, and thoroughly wash it with hot, soapy water, rinse, and dry. W

19OVEN BURNER AIR SHUTTER ADJUSTMENT Before attempting to adjust the oven burner air shutter, assure the following has been reviewed and is correct

Since 1880, we have been dedicated to quality! Our belief is that our success can only be measured by the continuing success of our customer

IN-OVEN BROILING To light the broiler burner, turn the oven control knob to the "BROIL" position. When the knob is in the "BROIL"

21 RAISED GRIDDLE/CHARBROILER, GRIDDLE & CHARBROILER Start-Up-Raised Griddle & Griddle The griddle must be “burnt-in” or “seasoned” prior to

22• Always pre-heat the griddle on low for approximately ten (10), minutes prior to use. NEVER pre-heat on high! TIP: Its much easier to raise sett

23• Stubborn dirt may be removed by rubbing the surface with a nylon pad and cooking oil. If necessary, flush the surface of a warm 200° griddle wi

24 SUGGESTED GRIDDLE SETTINGS Eggs Low Pancakes Medium High Hamburgers or Steaks (rare) High Hamburgers or Steaks (medium or well) Medium High Gri

COOKWARE Each cook has his or her preference for the particular cooking utensils that are most appropriate for their specific food preparation. Mos

26Limited Warranty WHAT IS COVERED? INITIAL SEVEN (7)-DAY WARRANTY This warranty covers all cosmetic components of your unit. All repair, labor a

27 MANUFACTURERS’ PERFORMANCE CHECKLIST This checklist has been developed to assure proper installation of your range or cooktop as well as instruc

28 28PROXIMITY TO CABINETS - SUPPLEMENTAL PROXIMITY TO CABINETS - SUPPLEMENTAL

29

3 (1/02) Printed in the U.S.A. We

30

31MANUFACTURERS’ PERFORMANCE CHECKLIST This checklist has been developed to assure proper installation of your range or cooktop as well as instructi

32 Fold Here _______________________________ _______________________________ _______________________________ Prizer-Painter Stove Works, In

4TABLE OF CONTENTS INSTALLATION 5-9 REQUIREMENTS 5 UNPACKING 6 HIGH-SHELF/STD. BACKGUARD/ISLAND TRIM INFO 6 PROXIMITY TO CABINETS 7 POSITIONING

5 INSTALLATION REQUIREMENTS 1. This unit has been designed to be installed directly against rear walls and side base cabinets. A backguard must

6UNPACKING 1. Check the packaging for any damage. If damage is visible, you should mark the bill of lading for possible concealed damage. 2. Che

PROXIMITY TO CABINETS 1. Base Cabinets: The unit may be installed directly adjacent to base cabinets at a maximum height of 36". IMPORT

8POSITIONING A rolling lift jack, air sled, or pallet jack should be used for positioning the unit. Do not push against the edges or sides of th

9pressure. The regulator used on this unit will withstand a maximum input pressure of 1/2 psi, (12" WC). If the incoming line pressure is high